ccna exploration exams

Just another weblog

CCNA Exploration 2 – Module 9 Exam Answers

1. What two actions will the EIGRP DUAL FSM take if a link to a network goes down? (Choose two.)
• put the route into passive mode
• query neighbors for a new route
• search routing table for a feasible successor
• run the SPF algorithm to find a new successor
• search topology table for a feasible successor

2. Host in the network illustrated is unable to ping host How must EIGRP be configured to
enable connectivity between the two hosts? (Choose two.)
• R1(config-router)# network
•  R1(config-router)# auto-summary
•  R1(config-router)# no auto-summary

• R2(config-router)# no auto-summary
• R2(config-router)# auto-summary
• R2(config-router)# network

3. Refer to the exhibit. The company is using EIGRP with an autonomous system number of 10. Pings between
hosts on networks that are connected to router A and those that are connected to router B are successful.
However, users on the network are unable to reach users on the network. What is the
most likely cause of this problem?
• IP classless is enabled and is causing the packet to drop.
• The command network was not issued on router C.
• The routers are not configured in the same EIGRP routing domain.
• Automatic summarization of the networks is causing the subnetted routes to be dropped.

4. What information is maintained in the EIGRP topology database for a destination route? (Choose three.)
• the routing protocol
• the feasible distance of the route

• the highest cost of the route
• the SRTT value for the route
• the route cost as advertised by the neighboring router
• the physical address of the gateway interface

5. On a router running EIGRP, what database would maintain a list of feasible successors?
• routing table
• neighbor table
• topology table
• adjacency table

6. Refer to the exhibit. What is indicated by the P at the beginning of the topology entry?
• the route is in a stable state
• the route is a preferred route
• DUAL is searching for a better route to this destination
• the exit interface is in passive mode and EIGRP advertisements are blocked

7. In the command router eigrp 20, what is the purpose of the number 20?
• specifies the administrative distance for all EIGRP routes
• identifies the autonomous system number this EIGRP process will advertise
• determines what metric is added to all advertised routes
• indicates the number of addresses in the EIGRP routing domain

8. Refer to the exhibit. In the topology table, what do the numbers 3011840 and 3128695 represent?
• the route metric that is applied to those EIGRP routes for this router
• the trustworthiness of the routing information source
• the composite of the hop count and bandwidth to that destination network
• the total metric for that network as advertised by the EIGRP neighbor

9. Which two statements describe characteristics of EIGRP? (Choose two.)
• EIGRP is a distance vector routing protocol.
• EIGRP supports classless routing and VLSM.

• EIGRP is classified as a link-state routing protocol.
• EIGRP uses TCP for reliable delivery of EIGRP update packets.
• With EIGRP, loop-free paths are achieved through the use of hold-down timers.
• EIGRP sends a periodic update every 30 minutes.

10. Refer to the exhibit. Network goes down. What type of packet does Router2 immediately send
to Router1 and Router3?
• a query for network
• an acknowledgment packet to
• an update packet that is sent to
• a packet that contains the new routing table for R2
• unicast update packets to and

11. Refer to the exhibit. Network goes down. What type of packet does Router2 immediately send
to Router1 and Router3?
• a query for network
• an acknowledgment packet to
• an update packet that is sent to
• a packet that contains the new routing table for R2
• unicast update packets to and

12. What administrative distance would a router assign to a default route in EIGRP that is learned from a source
external to the autonomous system?
• 1
• 5
• 70
• 90
• 170
• 190

13. In which of the following tables does the EIGRP DUAL algorithm store the primary route to a destination?
(Choose two.)
• routing
• topology

• neighbor
• path
• shortest path

14. Which of the following types of routes will be denoted by EX in EIGRP routing table entries? (Choose two.)
• routes learned from other routing protocols
• routes learned from any non-adjacent EIGRP routers
• any route with a hop count metric higher than 224
• EIGRP routes that originate in different autonomous systems
• all passive routes in the routing table

15. Which term defines a collection of networks under the administrative control of a single entity that presents a
common routing policy to the Internet?
• autonomous system
• contiguous networks
• process ID

16. Refer to the exhibit. EIGRP is the only routing protocol enabled on this network. No static routes are c
on this router. What can be concluded about network from the exhibited output?
• A route to network is not listed in the routing table.
• Packets that are destined for will be forwarded to
• EIGRP will perform equal cost load balancing across two paths when forwarding packets to 198.18

17. The router with interface is a successor for network
Refer to the exhibit. All interfaces have been configured with the bandwidths that are shown in the example
Assuming that all routers are using a default configuration of EIGRP as their routing protocol, what
packets take from the network to the network?
• A,B,E
• A,C,E
• A,D,E
• Packets will load balance across the A,B,E and A,C,E paths.
• Packets will load balance across the A,B,E and A,D,E paths.
• Packets will load balance across the A,C,E and A,D,E paths.

18. By default, which two metrics are used by EIGRP to determine the best path between networks?
• load
• delay
• bandwidth

• reliability

19. Which of the following statements describes the bounded updates used by EIGRP?
Bounded updates are sent to all routers within an autonomous system.
• Partial updates are sent only to routers that need the information.
The updates are sent to all routers in the routing table.
Updates are bounded by the routers in the topology table.

20. The show ip eigrp topology command output on a router displays a successor route and a feasible successor
route to network In order to reduce processor utilization, what does EIGRP do when the
primary route to this network fails?
• The router sends query packets to all EIGRP neighbors for a better route to network
• The DUAL FSM immediately recomputes the algorithm to calculate the next backup route.
• Packets that are destined for network are sent out the default gateway instead.
• The backup route to network is installed in the routing table.

21. Refer to the exhibit. Based on the output of show ip eigrp neighbors, what are two possible problems with
adjacencies between Router1 and Router2? (Choose two.)
• The routers are configured with different EIGRP process IDs.
• Automatic summarization was disabled.
• The hello timer for R1 was altered.
• The serial interfaces for both routers are in different networks.
• No feasible successors were found.

22. Refer to the exhibit. This is the debug output from 2 directly connected EIGRP routers. They are not
forming an adjacency. What is the cause?
• one router is a non-cisco router
•  they have different autonomous-system numbers
• they are using difference sequence numbers
• they are sending incorrect hello types

23. Refer to the exhibit. Which command will advertise the network but not the
network on router A?
• network
• network
• network
• network
• network


April 19, 2009 - Posted by | Uncategorized

No comments yet.

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: